WIFI Protected Setup or WPS

WPS or WIFI Protected Setup is by far the easiest method to connect wireless clients to your main wireless router. There are some routers that don’t support WPS or WIFI Protected Setup. There are two methods for WIFI Protected Setup or WPS, First method is… Read More »WIFI Protected Setup or WPS

How To Reset BrosTrend Extender?

If you want to reset brostrend extender. Then this guide will surely help to get your extender to reset to the factory setting. But, before we dig into the process of resetting the extender. We need to understand in what cases, we need to reset brostrend extender.

  • In case, if you change the router’s Wi-Fi Name and Password.
  • If you change your internet service provider (ISP) and router.
  • If You forget your login password.

All these scenarios are the most common reasons, people want to reset their extneder.

To reset your extender,

  • Plug your extender to the power and wait for the solid light.
  • Once you get solid light, then use a paper clip.
  • Insert paperclip in a factory reset hole and hold it for about 10 seconds.
  • Light will start blinking, then take out the paperclip and let it boot up.
  • It will take about 1 minute to boot up.

To check if your extender is reset or not. You can go to the Wi-Fi settings on your device and check if you are getting BrosTrend_EXT under Wi-Fi connections. If you are getting, BrosTrend_EXT, it means your extender is reset to the factory settings.

Setup BrosTrend Extender Via WPS

To Setup BrosTrend Extender via WPS. Make sure WPS is enabled on the router. To enable WPS on router, user can login on to the router and enable it. Secondly, if user do not know how to do it. Then, he can call his router provider and tell them to enable WPS on the router.

Once, the WPS is enable on the router. Then, plug your extender to the power and wait for the solid power light on power. Now, user can press WPS on router and within 2 minutes press the WPS on the extender as well.

After, pressing WPS on both, you will get two lights on it (Power and Signal). If you are getting two lights that means the extender is working.